Hostel Shoppe - Vision VR40 Assembly Guidelines ... Page 3

Hostel Shoppe - Your Recumbent Bicycle, Tricycle, and Tandem Headquarters

Order Hostel Shoppe's 2004 Recumbent Catalog

Hostel Shoppe's FREE Recumbent Classified Ads

Tech Tips, Recumbent Info, and Expert Advice

Store Policies, Ordering Info and all about US

< Previous ] [ Next >
[1] [2] [3] [4]

Vision VR40 Assembly Guidelines ... Page 3

Insert the quick release skewer into the rear wheel and the rear wheel into the frame. Be sure the axle is set fully into the frame and tighten the skewer securely.

The rear brakes have been adjusted and tested prior to shipping. Simply insert the brake noodle into it's holder and test the brakes. If the brake does not appear to be adjusted properly, double-check to be sure the wheel is centered in the frame properly before making any adjustments!

Squeeze the brake lever firmly several times and spin the wheel to be sure the brake does not touch the tire at any point.

If the pads need to be centered, tighten the small adjustment screw on the brake arm that is too close to the rim. Again, before making any adjustments, be sure the rear wheel is in the frame properly.

Insert the quick release skewer into the front axle and insert the wheel into the fork. Be sure the wheel is centered in the fork as shown.

Route the brake cable over the stem and around the backside of the fork as shown. Insert the brake noodle into the holder.
Note: OSS bikes are routed the same.

< Previous ] [ Next >
[1] [2] [3] [4]

Vision VR40 Assembly Guidelines ... Page 3
	Insert the quick release skewer into the rear wheel and the rear wheel into the frame. Be sure the axle is set fully into the frame and tighten the skewer securely.
	The rear brakes have been adjusted and tested prior to shipping. Simply insert the brake noodle into it's holder and test the brakes. If the brake does not appear to be adjusted properly, double-check to be sure the wheel is centered in the frame properly before making any adjustments!
	Squeeze the brake lever firmly several times and spin the wheel to be sure the brake does not touch the tire at any point.
	If the pads need to be centered, tighten the small adjustment screw on the brake arm that is too close to the rim. Again, before making any adjustments, be sure the rear wheel is in the frame properly.
	Insert the quick release skewer into the front axle and insert the wheel into the fork. Be sure the wheel is centered in the fork as shown.
	Route the brake cable over the stem and around the backside of the fork as shown. Insert the brake noodle into the holder. Note: OSS bikes are routed the same.